printer.cfg

[include ConfigFiles/includes.cfg]

#*# <---------------------- SAVE_CONFIG ---------------------->
#*# DO NOT EDIT THIS BLOCK OR BELOW. The contents are auto-generated.
#*#
#*# [probe]
#*# z_offset = -0.575
#*#
#*# [heater_bed]
#*# control = pid
#*# pid_kp = 43.789
#*# pid_ki = 1.248
#*# pid_kd = 384.252
#*#
#*# [extruder]
#*# control = pid
#*# pid_kp = 38.788
#*# pid_ki = 5.877
#*# pid_kd = 64.000
#*#
#*# [input_shaper]
#*# shaper_type_x = ei
#*# shaper_freq_x = 49.8
#*# shaper_type_y = mzv
#*# shaper_freq_y = 30.6
#*#
#*# [bed_mesh default]
#*# version = 1
#*# points =
#*# 	-0.080000, 0.046250, 0.055000, 0.063750, 0.053750, 0.063750, 0.047500
#*# 	-0.026250, 0.016250, 0.040000, 0.026250, 0.041250, 0.051250, 0.031250
#*# 	-0.006250, -0.013750, 0.025000, 0.042500, 0.030000, 0.056250, 0.015000
#*# 	-0.068750, 0.011250, -0.002500, 0.000000, 0.042500, 0.007500, 0.037500
#*# 	-0.052500, -0.025000, 0.015000, 0.006250, 0.010000, 0.015000, 0.008750
#*# 	-0.015000, 0.008750, 0.018750, 0.051250, 0.053750, 0.026250, -0.008750
#*# 	0.036250, 0.057500, 0.076250, 0.081250, 0.106250, 0.070000, 0.035000
#*# tension = 0.2
#*# min_x = 61.0
#*# algo = bicubic
#*# y_count = 7
#*# mesh_y_pps = 2
#*# min_y = 61.0
#*# x_count = 7
#*# max_y = 287.98
#*# mesh_x_pps = 2
#*# max_x = 287.98