forrtl: severe (59): list-directed I/O syntax error, unit 100

[AlvaroJPZ]

Please, how can I solve this error:

forrtl: severe (59): list-directed I/O syntax error, unit 100, file E:\1.ALVARO\Archivos personales2\Terceros\Lavalin\Anura2\Sec3bs.A3D\Sec3bs.GOM
Image PC Routine Line Source
Anura3D_2023.exe 00007FF76A605965 Unknown Unknown Unknown
Anura3D_2023.exe 00007FF769DCE14F Unknown Unknown Unknown
Anura3D_2023.exe 00007FF76A5D3D6A Unknown Unknown Unknown
Anura3D_2023.exe 00007FF76A5D4C41 Unknown Unknown Unknown
Anura3D_2023.exe 00007FF76AABE3AB Unknown Unknown Unknown
Anura3D_2023.exe 00007FF76EF5EB74 Unknown Unknown Unknown
KERNEL32.DLL 00007FFEDED07344 Unknown Unknown Unknown
ntdll.dll 00007FFEE07A26B1 Unknown Unknown Unknown

E:\1.ALVARO\Archivos personales2\Terceros\Lavalin\Anura2\Sec3bs.A3D>PAUSE

Thanks in advance.

[Emre-ncche]

I believe this error caused by several reasons.
First, I would say take a look at the input parameters and re-consider that whether any of them creates a conflict.
If you use double-point, it would be better to apply double point: define additional parameters.
This error also comes if the just created Anura3D folders does not exist anymore in the directory (such as .GOM file)

[AlvaroJPZ]

thank you very much. Some thing I realized, was that when I put "Generate Anura3D files", It was created two diferents folders: .A3D and .Gid. I dont know if that was correct.
At first there was an error because, for some reason, didnt copy A3DMohrCoulombStandard.dll, it was missed. So I copied manually. It could be that I did no compile right Anura3D?
You are very kind for answer, I very new on this.

[Emre-ncche]

If you once compile successfully Anura3D, you do not have to copy manually any .dll files from the main folder. If you watch the steps on the manual, I am sure you will able to calculate

[AlvaroJPZ]

I had a very dense mesh on some areas, that could be the reason for that error?

[Emre-ncche]

You should be sure if you compile Anura3D succesfully based on the previous conversation. If you are sure, then you should look at the directory where all the generated Anura3D files via GiD exist.

[AlvaroJPZ]

I redid all, deleted some points in order to created not thath dense mesh. Again, the A3DMohrCoulombStandard.dll was not automatically copied when the files were created, but I copy manually and It works, the error didnt came.

I am running a runout analysis, on dry conditions, may be you could help me defining all calculate data, I am not sure about the inicial conditions, my reference is the sliding blocks example from the manual.

[CH-max92]

Hi , AlvaroJPZ.
In this case, there is usually something wrong with the grid. It is also possible that there are some potential conflicts in the material parameters settings. As for the lost of the .dll file, I suppose that you didn't compile the code for anura3D properly.