Unable to load TFT file to the Panel

[hagbard523]

Hey,

I'm new here and I try to get everything done as explained.
Unfortunately im not able to get the TFT on the Panel. When is try to do it with the Button on the devices Page, nothing happens.
It shows ESPHome and Blueprint Version 4.3.12 But nothing for TFT.
So the Log shows a "Version mismatch"

Additionally the log shows very often this massage: "Nextion reported variable name invalid!"

Any Idea how to fix this?

Thanks a lot in advance.

[edwardtfn]

Could you please share the ESPHome logs from the moment you press the Upload TFT button and for a.couple of minutes after this?

[hagbard523]

So I have to copy that

# Set IP address manually
wifi:
  networks:
    - id: !extend wifi_default
      manual_ip:
        static_ip: 192.168.0.123
        gateway: 192.168.0.1
        subnet: 255.255.255.0
        dns1: 1.1.1.1  

into the code in the nspanel esphome config?(and pit in my addresses of course)

[edwardtfn]

That's right. Add that at the end of your panel's yaml and flash it again (wirelessly is fine).

[hagbard523]

Is there anything to change in the id section?

hoe can I see if the install was successful?

[edwardtfn]

Is there anything to change in the id section?

No. Keep that as it is, otherwise it will fail.
Change only the IP addresses accordingly.

hoe can I see if the install was successful?

If it compiles, it is probably OK.
If your panel can resolve the DNS, pressing the Update button will update the screen. It takes some minutes, so you will know when it is going... 😉

[hagbard523]

The first tries have been unsuccessful. But after a restart of the esphome add on everything went fine.

Thanks a lot for your patience and your help!
Really appreciate it!!