After Config send, Blue Pill not right detected

[eviltheknivel]

Hello,

ich have the problem that after sending the Config the Board is not right detected in FreJoyConfiguratorQt. It was detected as " ONLY FLASH". When i push the Reset Button it will be right detected.
Debug is here.

15:45:26:830: Open HID device №1. VID"0483", PID"5752", Serial number "" 15:45:26:830: HID opened, connected devices = 1 15:45:32:919: 1 _**Here i pushed the Reset Button**_ 15:45:32:919: Open HID device №1. VID"0483", PID"5752", Serial number "4EE6ECDC1DFB" 15:45:32:920: HID opened, connected devices = 1

[vostrenkov]

Do you have your yellow jumpers inserted?

[eviltheknivel]

both to GND, yes

[vostrenkov]

How do you flashed the sw?
If you upgraded from 1.6.x via .bin file try to reflash hex 1.7.0

[eviltheknivel]

i flashed only the 1.7.0b3 hex file with ST Link Utility. No old Firmware. I will try tomorrow again.

[vostrenkov]

Also please do the photo of your board and MCU

[Reksotiv]

and share your config file

[eviltheknivel]

Buttonbox.zip

[Reksotiv]

STM32 Fakes

[eviltheknivel]

Fuck :-(

[eviltheknivel]

where can i get original?

[Reksotiv]

I dont know. It is very difficult to find the original at the moment. I have 3 boards and only one is not fake, but all work fine. Bought on aliexpress

[Assamita81]

Same problem here, board only works when resetting the board. Bought 7 off of Aliexpress. 5 of them do not work, the other two have this same problem. If only we could find a reliable source of original boards...