ESP32-S3 & ILI9488 Pinout and bin

[maix-me]

Hi everyone, how how to connect this display with this board?
i need bin firmware and piount to connect
I try to connet with this manual https://www.openhasp.com/0.7.0/hardware/generic/ili9341-ips/ but i did not hav GPIO23, GPIO26 and N/C

[lpacchin]

Hi
same combination as mine, you can try my compiled bin:

esp32-s3-ili9488_full_16MB_v0.7.0-rc11_4b6a002.bin

openHASP for:

esp32-s3-devkitc-1-n16r8

Pinout:

TFT_CS=10
TFT_DC=7
TFT_RST=6
TFT_BCKL=5
TFT_MOSI=11 Connect T_DIN of touch and SDI of TFT
TFT_SCLK=12 Connect T_CLK of touch and SCK of TFT
TFT_MISO=13 Connect T_D0 of touch (only)
TOUCH_CS=4

[maix-me]

Wich software do you use to flash this bin file?
I try tasmotizer and its send me error: Invalid head of packet And try Tasmota-PyFlasher-1.0 and its no sucsess with no error

[lpacchin]

I use https://web.esphome.io/

[maix-me]

its installed. But im not configure wifi. Witch password to here AP ?

[lpacchin]

https://www.openhasp.com/0.7.0/0.7.0/firmware/wifi-setup/
haspadmin

[maix-me]

You only this pin connect?
Pinout:

TFT_CS=10
TFT_DC=7
TFT_RST=6
TFT_BCKL=5
TFT_MOSI=11 Connect T_DIN of touch and SDI of TFT
TFT_SCLK=12 Connect T_CLK of touch and SCK of TFT
TFT_MISO=13 Connect T_D0 of touch (only)
TOUCH_CS=4

[lpacchin]

If do not see try to connect the TFT_BCKL to +3v maybe the backlight is too low
Also make sure you connect 3v3 and ground

[maix-me]

Thank you!