Powering Off taking too long

[ricardocb]

Hi, I'm using this micronova controller, and I'm facing the same issue of "too long power off".

I'm not getting any help with the multiple sending values like it is described here:

https://github.com/eni23/micronova-controller

Has anyone have a differente solution?

Right now, the power ON is ok, but the Power Off takes like 1 hour and it stays alwais on state "Final Cleaning"...

Is this common for everyone using this controller ?

[giuse320]

Hi, my stove with mod 0047 EVO it takes a few minutes longer than before.
Does it also indicate room temperature 0,0 to you when it is at least 20?

[Jorre05]

@ricardocb I've read the same observations elsewhere. My stove does not show this behaviour, so I'm unable to diagnose this.

[ricardocb]

Hi @giuse320 , regarding the external temperatura, check if tour stove hás an external temperatura sensor.

[matteobtt]

With my stove, the cleaning phase takes 50 minutes instead of the usual 8 minutes, I also noticed that when I turn on the stove the fume extractor starts immediately instead of after a few seconds.
In my opinion, it is due to the fact that by changing the address 0x21, you forcibly change the operating state without initiating the expected procedure to change it.
I would like to know if the Micronova's official AGUA/NAVEL module has the same problem or it sends different bytes, if anyone has it, can you analyze the transmitted bytes?

[ricardocb]

I don't know where I can buy this model AGUA/NAVEL.

Is it available in Italy? I could try to buy one to test it.

[matteobtt]

https://www.labottegadeiricambi.it/it/r/modulo-wifi-agua-navel-20-stufe-amg
https://www.ebay.it/itm/387470993872