Manual only shows Probe Signal Wire Connection, Website is also unclear

[ChaosBlades]

The Switchwire manual shows the diode and signal wire connection but just shows the positive and negative probe wires going to nothing.

The website could be more clear as well.
https://docs.vorondesign.com/build/electrical/sw_miniE3_v20_wiring.html
Says...
Plug Probe GND and Signal (with BAT85 diode) in to Z-STOP
Connect Probe +V to VIN in terminal next to HB

Sound Say...
Plug Probe Ground (Blue Wire) to Z-STOP GND and Signal (Black Wire) with BAT85 diode (black band facing away from connector) in to Z-STOP PC2
Connect Probe Positive (Brown Wire) to POWER 12/24V (The one just to the Left of BED)

[ChaosBlades]

Also, The Mainboard Breakout Board pictured on page 125, I can't find anything on this board. It isn't linked to, I cant find any reference to it anywhere, and I certainly can't find anywhere to buy it. All the Toolhead PCB listings for purchase only come with the Toolhead PCB. It also shows the Probe being connected from a 3-pin connector to a 2-pin connector via 1 Brown Wire. So it is not clear how this is supposed to be connected even if I could find anything on this mysterious board.

[Onlywavesmdp]

I have the same problem, were you able to solve it?