Program not letting reactor generate power

[RexTheCapt]

I have used the program for a while now and i did accidentally disconnect my rector from my power bank for a sec. my reactor overheated and the program stopped the reactor and worked like it should do.

The problem is the screen shows the output and input gate is going down all the time, right now both are synchronised going down and is at 20 rf/t. The temperature is 2,007 C and going very slowsly down.

I have tried to reboot the computer and even replacing the computer and installed the program again but every single time the input and output gate keeps going down.

I can't get the reactor to start generating power again.

[RexTheCapt]

And i cant adjust the output gate at all

[RexTheCapt]

Here is a video of the little problem https://www.youtube.com/watch?v=4DEEV4GsGKQ&feature=youtu.be

[spannerman79]

my reactor overheated and the program stopped the reactor and worked like it should do.

You have to wait until your reactor has fully cooled down from an overheat.

https://youtu.be/8rBhQP1xqEU?t=3m39s - I am going to assume you setup the same as what is shown there.

I have tried to reboot the computer and even replacing the computer and installed the program again but every single time the input and output gate keeps going down.

I assumed you re-int the wired modems that connect to the gate when you broke/removed/replaced the computer?

[RexTheCapt]

I have waited a long time. The reactor minimum is 2007 C degrees.

Yes i did setup the component exactly like in the video.

I did reconnect my wired modem to my computer again when broke it. I did not replace the other ones at all. Each try i did to make the rector work was spamming the tripple up arrows.

[Kolris]

Is there a solution for this? I'm trying to get it to work in 1.7.10, if that makes any difference.