Skip to content

Latest commit

 

History

History
56 lines (31 loc) · 2.51 KB

README.md

File metadata and controls

56 lines (31 loc) · 2.51 KB
Raw

About

Avnet IoTConnect AT Command Interface project example for the Renesas CK-RA6M5 v2.

This code is based on the CK-RA6M5 v2 Sample Code project and uses an IoTConnect AT Command-enabled PMOD module (e.g. DA16K based) as a gateway.

quickstart_ck_ra6m5_v2_ep Copyright 2023 Renesas Electronics Corporation and/or its affiliates.

Dependencies

The project uses the following dependent projects:

A fully set up DA16600 PMOD Module is required to be set up and connected to IoTConnect.

Follow the DA16K AT Interface Quick Start guide.

Supported Boards

Renesas CK-RA6M5 v2 Cloud Kit with DA16600 Wi-Fi-BLE combo module.

Supported IoTC Device Commands

You can add these to your device template in the IoTConnect Dashboard.

  • set_red_led <state>

    Controls state of red LED on the board

    • on - Turns red LED on
    • off - Truns red LED off

  • set_led_frequency <freq>

    Controls the frequency of the blue LED flashing on the board

    • 0 - Slow blinking
    • 1 - Medium blinking
    • 2 - Fast blinking
    • 3 - Very fast blinking

Getting Started

Follow the Renesas CK-RA6M5 v2 Quick Start Guide to set up your CK-RA6M5 v2 board for use.

Make sure the DA16x00 device is connected to the PMOD1 connector.

Follow the Quickstart Guide to flash the included binary image and use it.

Building & Development

Install the Flexible Software Package with e² Studio IDE.

The project is tested and built with FSP version 5.0.0, but it may work with later 5.x.x versions.

You can now open / import, build and debug the project as per the Renesas Quick Start guide.