imageproc-basic

Basic IDE project for an ImageProc 2.5 board.

Only the bare minimum of chip setup is done is done:

• Core clock and PLL to 40 Mhz Xtal
• Set GPIO modes and defaults on pins
• Start microsecond timer (sclock)

Example

An example is provided in this template, which should indicate if your board is "alive":

• LED_1 is turned on after setup
• In the main loop, LED_2 is toggled at 1Hz

Note that LED_1 should be RED, and LED_2 should be GREEN, but this varies greatly between boards.

Using this template

Follow examples of where to make further includes and setup calls. Examples are provided in comment lines.

Future

Further refinements will be made to this template in the future. Some of these must be kept in sync with imageproc-lib.

Planned:

• A single setup() function, akin to Arduino; yields a cleaner main()
• A single 'imageproc.h' header that encapsulates chip support and board support packages
• More stock examples
• Considerations for future portability (ARM Cortex M)