Wifi connection?
#485
Replies: 1 comment 1 reply
-
If you wait a few minutes, it will end up in hotspot mode automatically
You can also reset the firmware with these steps:
Disconnect the power
Press and hold both shifter buttons
Reconnect the power
Wait 3 seconds
Release the buttons.
This should reset the firmware
…On Mon, Oct 9, 2023, 7:18 p.m. Manlio Lo Conte ***@***.***> wrote:
Hey, i started setting up my smartspin today and i saw the WAP show up on
initial power up, but then i fat-fingered the password to my home wifi
network (i know, i know). I haven't been able to get the WAP to show up
again since then, the device powers, and then the LED starts blinking red,
nothing shows up in wifi settings. Is there a way to perform a reset and
start the process again? Thanks in advance.
—
Reply to this email directly, view it on GitHub
<#485>, or unsubscribe
<https://github.com/notifications/unsubscribe-auth/AF4U2PGYFU4VOZVDTVJNPKDX6SA5FAVCNFSM6AAAAAA5ZOUKAKVHI2DSMVQWIX3LMV43ERDJONRXK43TNFXW4OZVG4YTSMRSGY>
.
You are receiving this because you are subscribed to this thread.Message
ID: ***@***.***>
|
Beta Was this translation helpful? Give feedback.
1 reply
Answer selected by
doudar
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
Hey, i started setting up my smartspin today and i saw the WAP show up on initial power up, but then i fat-fingered the password to my home wifi network (i know, i know). I haven't been able to get the WAP to show up again since then, the device powers, and then the LED starts blinking red, nothing shows up in wifi settings. Is there a way to perform a reset and start the process again? Thanks in advance.
Beta Was this translation helpful? Give feedback.
All reactions