Name		Name	Last commit message	Last commit date
parent directory ..
Images		Images
README.md		README.md

README.md

Purchased Parts

Off the shelf parts you will need to complete this build

There are seperate folders and guides for each of these items:

Associated RC10T6 series truck
.12ci (2.1cc) Nitro engine
- I used an SH Engines .12 Pro Rear Exhaust Touring Car & Truck Nitro Engine (Turbo Plug) (SHEPT12R02SXT-1). This is basically the same as the old Dynamite Platinum 12, but with a slide carburetor. It's easy to tune, runs smooth, and has plenty of power for a 2WD truck.
Exhaust header/pipe
- There are 2 gas truck exhausts currently being made: Ignite RC (IG006) and RD Logics (61900 and 61905). Novarossi still has some new old stock 1/10th pipes which will work with the RD Logics header.
Air filter
- I used a Traxxas Complete Air Filter Set (TMX 2.5, 3.3) (TRA5260). It might seem too large for this carburetor, but the included zip-tie clamps it down good and it seals fine. Motorsaver.com also has some very nice 1/10th size filters for all sizes of carburetors.
75cc Fuel Tank (REDCAT 02004) These can be found on Amazon for around $10-$15. Make sure you get a genuine Redcat tank - I've had some cloned tank lids not seal at all.
Fuel Filter
- These tanks don't have filters, so this is necessary. I use a small Sullivan "Crap Trap" filter (SUL187).
Standard size silicon fuel line
32mm (Kyosho style) 1/8th scale clutch
- I used a Fioroni 32mm Quattro "Original RED" 4-Shoe Adjustable Clutch System (FIO-OT-FR104-R). I've been very happy with this setup, and since it is standard 1/8th stuff, you have lots of tuning options.
16T Mugen/OFNA style clutch bell
- I used a ProTek RC Hardened Clutch Bell w/Bearings (16T) (Mugen/OFNA Style) (PTK-7053) because it uses HUGE bearings which shouldn't wear out for a very long time.
Team Associated B6.1/B6.1D Standup Top Shaft (ASC91798)
Team Associated Throttle/Brake Linkage Set (ASC81251)
- Other similar linkage sets might work, but I really can't say for sure.
Silicon switch cover
- I used a Mugen Seiki Switch Cover (MUGB0401). Other 1/8th offroad switch covers are likely to work also.
Receiver switch
- I have a Sanwa receiver, so I used a Sanwa switch (SNW107A20064A). Since this kit uses LiPo receiver batteries, a charge plug is not necessary. I just plug the balance plug into my charger.
Receiver Battery (Mid - for smooth, high-grip tracks) - Mugen/AE/8ight-X style LiPo pack (85 x 30 x 17mm) - (PTK-5196)
Receiver Battery (Rear - for lower-grip tracks) - HB/8IGHT style LiPo pack (39 x 56 x 21mm) - (PTK-5171)
Screws
- 1 M3x? button head hex screws
- 1 M3x? countersunk flat head hex screws
Receiver / Servos (low profile servo for throttle)