forked from FreeRADIUS/pam_radius
-
Notifications
You must be signed in to change notification settings - Fork 0
/
pam_radius_auth.conf
52 lines (52 loc) · 2.52 KB
/
pam_radius_auth.conf
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
# /etc/pam_radius_auth.conf configuration file.
#
# For proper security, this file SHOULD have permissions 0600,
# that is readable by root, and NO ONE else. If anyone other than
# root can read this file, then they can spoof responses from the server!
#
# There are 5 fields per line in this file. There may be multiple
# lines. Blank lines or lines beginning with '#' are treated as
# comments, and are ignored. The fields are:
#
# server[:port] secret [timeout [source_ip [vrf]]]
#
# the port name or number is optional. The default port name is
# "radius", and is looked up from /etc/services The timeout field is
# optional. The default timeout is 3 seconds.
# The source_ip field is optional and the default is none.
# The vrf field is optional and the default is none.
#
# For IPv6 literal addresses, the address has to be surrounded by
# square brackets as usual. E.g. [2001:0db8:85a3::4].
#
# If multiple RADIUS server lines exist, they are tried in order. The
# first server to return success or failure causes the module to return
# success or failure. Only if a server fails to response is it skipped,
# and the next server in turn is used.
#
# The timeout field controls how many seconds the module waits before
# deciding that the server has failed to respond. Timeouts MUST be
# between 3 and 60 seconds. If they are outside of this range, the
# timeouts are clamped to this range.
#
# The source_ip field can be used to make the library bind the socket
# that connects to that particular server to a particular IP address.
# Note: specifying a timeout field is mandatory due to config parsing,
# but if not needed it can be just set to the default of 3.
#
# The vrf field can be used on Linux to make the library bind the socket
# that connects to that particualar server to a particular VRF.
# See: https://www.kernel.org/doc/Documentation/networking/vrf.txt for
# more information.
# Note: specifying a source_ip field is mandatory due to config parsing,
# but if not needed it can be just set to 0.
#
# server[:port] shared_secret timeout (s) source_ip vrf
127.0.0.1 secret 3
other-server other-secret 5 192.168.1.10 vrf-blue
[2001:0db8:85a3::4]:1812 other6-secret 3 [2001:0db8:85a3::3] vrf-red
other-other-server other-other-secret 5 0 vrf-blue
#
# having localhost in your radius configuration is a Good Thing.
#
# See the INSTALL file for pam.conf hints.