At start you will see this screen.
Notice at the bottom-right of the screen that the endstops status are displayed. Check their status before starting the experiment.
After you have pressed the knob, you will find a menu in which you can select from these options:
- Homing (moving to the absolute zero position).
- Moving a relative distance from where the gantry is
- Getting information from the last experiment
To select the desired option, turn the knob and push when the desired option is active.
If you select this option, you have to choose the speed. From 1 mm/h to 100 mm/h. Move to the units and tens to select the value.
Once you have selected the speed and distance, select Go! to start the experiment. There will be another confirmation message before starting.
In this option you have to choose the speed (as in the Homing option) and also you have to select the relative distance you want to travel
Once you have selected the speed and distance, select Go! to start the experiment. There will be another confirmation message before starting.
Displays the information related to the last experiment. Press the knob when you are done.
When the Sandbox is moving, it will display the information of the experiment.
Press the Kill button to abort the operation
Unless you disconnect the power supply of the Sandbox while moving, it will save the actual position even if it is switched off. This is useful if the preparation of the experiment takes time. So you can move the gantry to the desired position. Prepare the experiment, and then switch on the Sandbox and start the experiment.