Synology
Start a Discussion or join our Discord Server for Machinaris support and to help out other users.
First, you'll need to enable the Docker package on your Synology NAS.
Then using the Docker admin UI offered by Synology, search for the 'machinaris' image and download it:
Switch to 'Advanced Settings'.
Next, to farm your plots, add a volume mount for each folder (or a common parent), example shown:
You must also have a read/write application data volume, ideally on an SSD, which maps to /root/.chia in the container. Failure to configure this means each restart of the Machinaris container will be a fresh install, resulting in a full blockchain sync taking days.
If you are only going to farm your plots, then make those mounts read-only. If you are also going to plot to those paths, then make then read/write for Machinaris.
Leave network type as Bridge:
Leave default ports as shown:
Most importantly, you must set plots_dir. DO NOT REMOVE any variables, just leave default values if unsure.
If running as a harvester, you must set mode=harvester and controller_host and farmer_address to the IP of your Machinaris controller. Also must set worker_address.
Then run the container and view the terminal output:
You can also click the 'Create' button to create a terminal and enter bash to get an in-container shell if needed.
Browse to http://IP_OF_SYNOLOGY:8926 to view the Machinaris fullnode/controller WebUI.
The first container (above) provides the Chia blockchain fullnode and also the Machinaris WebUI (aka controller_. You may wish to choose to also farm your plots against other blockchain forks such as Flax, N-Chain, HDDCoin, etc. To do so, you will launch another container such as machinaris-flax which will farm that blockchain and report status to the main Machinaris container in the background. The single Machinaris WebUI from the controller container is still where you will monitor both blockchains for your entire farm.
For example, set the following Environment Variables on machinaris-flax container. Ports will be different for the other machinaris-FORK container.
- controller_host: IP address of the machine running main machinaris container. Could be same machine you are about to run machinaris-flax on.
- worker_address: IP address of machine you are about to run machinaris-flax on.
- worker_api_port: 8928 (for Flax)
- mode=fullnode
- blockchains=flax
Network: Bridge Ports to allow in:
- 8928:8928
- 6888:6888
- 6885:6885
The quickest way to get the settings you need is to fill in the form at https://www.machinaris.app/ Then just translate the section of docker-compose.yml (Variables, Ports, Volumes) into the GUI settings within the Synology Docker