Enable FPV Logo on ICC

canbus.com.au

To enable the FPV logo as the splash image on your ICC, for the mkI Fg Falcon follow these steps. This is free and your car doesn't require any updates or software installed on it, as the owner of the vehicle you already have it installed on your ICC, it just requires enabling in the module configuration. ~~I believe this only will work for colour screens on a mkI Falcon~~. Monochrome + Colour FDIM's have FPV Logo option.

How to activate with Forscan

Hardware Required:

mkI Fg Falcon with colour tft screen OR monochrome screen. Works with both!
OBD Adapter with MS-Can support
Laptop

Software Required:

Forscan with Extended License

Take a back up of your As Built Data.

It is always a good idea to take a backup of your vehicles data before modifying any configurations. This can be done in Forscan via the Module Configuration section.

Select the Module to be Backed Up, ie Front Display Interface Module(AS BUILT)
Flick over to ms-can on your switch when prompted.
Select Save & Save the .abt file
Select the Stop Icon to exit the configuration

Activate the FPV Logo

The FPV Splash logo can be activated in the Front Display Interface Module Configuration.

In Forscan under Module Configuration, Select the Front Display Interface Module Standard Configuration, NOT the As Built Mode. Flick the ms-can switch when prompted.
Select the option for FPV Logo and set it to Enabled
Cycle the Ignition if instructed to do so
Write the changes to module by clicking write, confirm your changes are correct.
Select the Stop Icon to exit the configuration
You have added the FPV logo, (this adds 75 rwkw) Check it out! *

works for me
Forscan

Troubleshooting

If in need of help troubleshooting this, try the forscan.org forums, fordforums.com.au or email me at service [at] canbus.com.au, no charges will apply.