3d print file for a R3D Propane Gauge Module

[DavePanetta]

Checklist

• I made sure that there are no existing issues or discussions - open issues,closed issues,open discussion, closed discussion - which may answer my question or that I could contribute my information to.
• I have read the Known Issues Wiki Page and my question / issue is not listed.
• I have provided the version of the software and the operating system in my post.
• If I have an issue with genmon not communicating with the controller, I have read and followed the serial troubleshooting guide.

Version

Genmon
Version V1.19.02

Have you submitted your log files from the About page? Note that outbound email must be working for logs to be submitted.

I have not submitted logs

What is/are your question(s)?

I was wondering if anyone had 3D printed the R3D Propane Gauge plastic tabs rather than buy a whole gauge just for the plastic tab to be used for a DIY tank reader. I don't have the skill or 3D printer to do it myself.

If I can get a file for one, I know someone that could print me a few.

Thanks
Dave

Additional information

No response

[jgyates]

I don't recall anyone doing this.