Power off generator #1208
-
Checklist
VersionVersion V1.19.04 Have you submitted your log files from the About page? Note that outbound email must be working for logs to be submitted.I have not submitted logs What is/are your question(s)?When a power outage occurs, Is there a way to manually turn off the generator via genmon. There have been times when we didnt want the generator to run for a few hours during the night. If not, is there other ways to turn it off without having to go outside to the generator? Additional informationNo response |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 2 replies
-
|
The controller does not allow that, it ignores stop commands when it is running in a power outage. 2-wire with an electronically controlled I believe would allow it, but I don't know what the conversion is or what drawbacks 2-wire may have. |
Beta Was this translation helpful? Give feedback.
-
|
this video shows how to do this. https://www.youtube.com/watch?v=ssZ1m-kyEek The genmon software will not allow this to occur automatically due to the firmware of the controller's remote commands only allow a stop if a remote start is issued first. |
Beta Was this translation helpful? Give feedback.
-
|
Thank you for the reply! |
Beta Was this translation helpful? Give feedback.
The controller does not allow that, it ignores stop commands when it is running in a power outage. 2-wire with an electronically controlled I believe would allow it, but I don't know what the conversion is or what drawbacks 2-wire may have.