SET_GCODE_OFFSET not working?

[Finnitio]

I just installed klipper-macros and have had trouble using SET_GCODE_OFFSET to adjust nozzle height. I was jused to adjust SET_GCODE_OFFSET while printig and than storing that value to the printer.cfg file.

I installed klipper-macros and disabled all my macros in printer.cfg. I added the G-Codes in SuperSlicer. When i started a print I was not able to adjust the z-offset and than save it. It seemed like SET_GCODE_OFFSET X did not have any influence on z height. I can't explain why, since the manual mentions that SET_GCODE_OFFSET has been replaced by klipper-macros.

Any ideas?

Thank you.