can I use esp3d webui 3.0 with btt tft35+esp01s?

[4kardes]

can I use esp3d webui 3.0 with btt tft35+esp01s?

How?
which bin file and index.html.gz ?

[luc-github]

can I use esp3d webui 3.0 with btt tft35+esp01s?

Yes

How?

you need to install ESP3D V3 and use ESP3D-Webui 3.0 because WebUI V3 is not compatible with ESP3D V2.1

which bin file and index.html.gz ?

There is no bin you need to compile the FW : https://github.com/luc-github/ESP3D/tree/3.0
The index.html.gz dependend of usage and target FW : https://github.com/luc-github/ESP3D-WEBUI/tree/3.0/dist

[4kardes]

thanks

[4kardes]

Building .pioenvs\esp8266_1MB_wifi\firmware.bin
I can make it but
cant Update ESP3D Firmware section on UI: 2.1b77 / FW: 2.1.0.c26 It process to %100 and reboot but there is no change.
I use esp3d configurator for platformio.ini and configuration.h

[luc-github]

you cannot use webupdate , you need to flash manually using btt writer or any usb to serial converter
the version used by btt is very old and web update just failed quietly

[Stiebl]

I tried to use the V3.0 on my TFT 35 with ESP-01s. But when plugged in to the TFT it keeps the serial communication busy. Therefore the printer cannot be used anymore. When i plug in the ESP-01 printer does no longer accept commands. Temp readings are still there but nothing else works.
Any Idea how to solve this?

[Stiebl]

:D :D so the reason why the terminal is spammend with temp reports will be the Marlin firmware and not the esp3d?

[luc-github]

yes, you can disable verbose in terminal menu, it will be more clean

[Stiebl]

Thanks again for your fast response and for all you effort you put in this :)
i really appreciate your work.

[Stiebl]

I still had problems with the ESP blocking the printer also with boot delay set to 100.
I digged into the code and removed the ESP_SERIAL_CLIENT from activeClients in esp3doutput.cpp. Now the ESP just puts the M117 commands to the serial port and no longer the echo commands.
Since then i had never again a problem with the ESP blocking the printer. Also tested is with original boot delay of 10000 and had no problems anymore.
Is there a way to reach this without manipulating the source code? Maybe i missed some configuration?

My observation was even with boot delay set to 100ms sometimes the connection to the wifi happened after the printer was attached to the TFT. Then the echo output on the serial port disturbed the printer and it no longer reacted to commands.
(I am using an Ender 3 pro with TFT 35 and a SRK mini E3 V3.0 board with Marlin 2.1.x)

Maybe changing line 80 in esp3doutput.cpp from
#if COMMUNICATION_PROTOCOL == RAW_SERIAL || COMMUNICATION_PROTOCOL == MKS_SERIAL

to
#if !defined(HAS_SERIAL_DISPLAY) && (COMMUNICATION_PROTOCOL == RAW_SERIAL || COMMUNICATION_PROTOCOL == MKS_SERIAL)

will solve the issue for my setup while not damaging the other possible setups?

[luc-github]

please open an issue, fill template of question and share your configuration.h in issue