You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I'm running an Ender 3 V2 and I'm replacing the motherboard. I've followed all of the videos and how-to's but I can not get the Bltouch to deploy when homing the Z-axis. Attached is the config file I'm using.
The Bltouch will start-up and deploy with it's self-test but not when homing the z-axis.
I've tried both using the Servo method and the z-axis end stop method. Neither are working.
I'm running an Ender 3 V2 and I'm replacing the motherboard. I've followed all of the videos and how-to's but I can not get the Bltouch to deploy when homing the Z-axis. Attached is the config file I'm using.
The Bltouch will start-up and deploy with it's self-test but not when homing the z-axis.
I've tried both using the Servo method and the z-axis end stop method. Neither are working.
Please advise.
Configuration.txt
The text was updated successfully, but these errors were encountered: