Tutorial : Hello world (Blinking LED)
If you do not know how to create a new project have a look to the tutorial How to create a new project ?.
In this tutorial we will see how to create a blinking LED with the Arduino Designer.
In this example we use the Arduino Uno platform and hardware components from the DFRobot Ardublock kit.
The hardware is defined as below :
The DFRduino Uno R3 platform is used and the blue LED module is connected to the pin 13 of the Arduino board.
For the sketch, blinking an LED means :
- wait a certain
delay - set the blue LED to
ON - wait again
- set the blue LED to
OFF - loop...
Finally, click on the Upload button from the toolbar to upload the code to the Arduino board.