You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
You'd have to move to a UART-based implementation to interface with the MHZ-19 to use the temp sensor and to trigger calibration. @skotopes has one here.
In my case though I'm already using the UART for a PMS5003 sensor, so I'd need to either remove that, or figure out a way to use UART for both devices to do that. Discussing ways forward for that here.
Hello Nikita,
This is superb implementation, may I suggest to add also the temperature as the module has a sensor too ?
Thanks
Sam
The text was updated successfully, but these errors were encountered: