printer.cfg

# This file contains common pin mappings for the BigTreeTech SKR PRO.
# To use this config, the firmware should be compiled for the
# STM32F407 with a "32KiB bootloader".

# The "make flash" command does not work on the SKR PRO. Instead,
# after running "make", copy the generated "out/klipper.bin" file to a
# file named "firmware.bin" on an SD card and then restart the SKR PRO
# with that SD card.

# The configuration is very specific for a heavily modified Ender 5.
# By heavily modified I mean literally everything except the frame!
# And even that has been stiffed and improved with belt tensioners, linear rails and brackets
# So don't just blindly apply the config, but rather use it as inspiration
# to set up your printer.

# 2021 - FrankenEnder - Marc Plogas

########################################
## generic printer configuration
########################################
[mcu]
serial: /dev/serial/by-id/usb-Klipper_stm32f407xx_390026000F47313335343634-if00 #/dev/ttyACM0
baud: 250000
restart_method: rpi_usb

# [filament_switch_sensor filament_sensor]
# switch_pin:PD10

[printer]
kinematics: cartesian
max_velocity: 600 #1000
max_accel: 1000
max_z_velocity: 7
max_z_accel: 100

[include stepper_xyz.cfg]
[include heater.cfg]
[include extruder_volcano.cfg]
#[include extruder_v6.cfg]
[include fans.cfg]
[include bltouch.cfg]
[include pins.cfg]
#[include resonance_compensation.cfg]
#[include input_shaper.cfg]
[include mainsail.cfg]
[include mainsail_variables.cfg]
[include macros.cfg]

#*# <---------------------- SAVE_CONFIG ---------------------->
#*# DO NOT EDIT THIS BLOCK OR BELOW. The contents are auto-generated.
#*#
#*#
#*# [bed_mesh default]
#*# version = 1
#*# points =
#*# 	0.087719, 0.110275, 0.082706
#*# 	-0.005013, 0.012531, 0.017544
#*# 	0.140350, 0.152881, 0.140350
#*# tension = 0.2
#*# min_x = 20.0
#*# algo = bicubic
#*# y_count = 3
#*# mesh_y_pps = 3
#*# min_y = 12.0
#*# x_count = 3
#*# max_y = 195.0
#*# mesh_x_pps = 3
#*# max_x = 164.99