You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Would it be possible to publish the stl file for the shaft-alignment-jig? As it seems very important to center the collar on the wheel it seems impossible to assemble a feeder without the jig.
Also the height of the drive wheel shim would be important to assemble the feeder correctly.
The text was updated successfully, but these errors were encountered:
Would it be possible to publish the stl file for the shaft-alignment-jig? As it seems very important to center the collar on the wheel it seems impossible to assemble a feeder without the jig.
Also the height of the drive wheel shim would be important to assemble the feeder correctly.
The text was updated successfully, but these errors were encountered: