Trouble to set detectors to Coincidence mode

[Kristalek]

Hello,

I have a problem with setting two detectors to coincidence mode. I saw a video on Youtube, did the same but it did not work. I am using the code witch is cooperating with SD card. Do you have any idea?

Have a nice day

[spenceraxani]

Hi, The 3.5mm connectors are often rather tight when used for the first few times. Could you make sure that you’ve inserted the cable properly? I often see that the cable is not quite fully inserted. Other than that, there’s little else that could be going wrong. I would check the solder connections on the 3.5mm connector. Best, Spencer ─ Dr. Spencer N. Axani ***@***.*** ***@***.***> Assistant Professor The University of Delaware 203 Sharp Lab 104 The Green, Newark, DE 19716 (608) 572-8426

…

On Apr 11, 2023, at 3:15 PM, Kristalek ***@***.***> wrote: Hello, I have a problem with setting two detectors to coincidence mode. I saw a video on Youtube, did the same but it did not work. I am using the code witch is cooperating with SD card. Do you have any idea? Have a nice day — Reply to this email directly, view it on GitHub <#105>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AANF5OZSERNV4ZGT3SYF2MLXAWUVXANCNFSM6AAAAAAW2VZX5M>. You are receiving this because you are subscribed to this thread.