For DaRk_dOg and Triano's mods, allows the use of a larger Y stepper motor without having clearance issues with the enclosure or the y carriage by inverting the pulley.
Pictured is a 48mm e3d high-torque motor fitting easily in the same space as the original motor. I recommend at least using the extruder motor and having some Y over-travel so all of the bed can be covered with a mesh. This is slightly more fiddly and requires smaller SHCS not BHCS screws, but I've been using it for months on VS.373 successfully.
Note I may have made a mistake with the BOM, the specified switchwire motors are 39mm NEMA17 Motor 17HS15-1504S1 and I picked these e3d High Torque 0.9° and likely sanity checked the size against trident/2.4 BOM motors.
