run-valgrind.sh

#!/bin/bash
#set -x

N=1 # number of simulations
enableTraces=1 # enable generation of ns-3 traces 
e2lteEnabled=1 # enable e2 reports from lte macro cell
e2nrEnabled=1 # enable e2 reports from nr secondary cells
e2du=1 # enable reporting of DU PM containers
e2cuUp=1 # enable reporting of CU UP PM containers
e2cuCp=1 # enable reporting of CU CP PM containers
trafficModel=0 # Type of the traffic model at the transport layer [0,2], can generate full buffer traffic (0), half nodes in full buffer and half nodes in bursty (1), bursty traffic (2)
configuration=1 # 0: NR carrier at 850 MHz, low traffic | 1: NR carrier at 3.5 GHz, low traffic | 2: NR carrier at 28 GHz, high traffic
minSpeed=2.0 # minimum UE speed in m/s
maxSpeed=4.0 # maximum UE speed in m/s
simTime=0.3 # simulation time
e2TermIp="10.244.0.240" # actual E2term IP interface
basicCellId=1 # The next value will be the first cellId
ues=3 # Number of UEs for each mmWave ENB
reducedPmValues=0 # use reduced subset of pmValues
EnableE2FileLogging=0 # enable offline generation of data

# Remove NoAuto on handover and Outage Threshold to use the Dynamic TTI HO
outageThreshold=-1000.0 # use -5.0 when handover is not in NoAuto 
handoverMode="NoAuto" # can be also

#for i in $(seq 1 $N); do
#  echo "Running simulation $i out of $N";
./waf --command-template="valgrind --leak-check=full --show-reachable=yes --track-origins=yes %s --RngRun=1 \
                                   --configuration=$configuration \
                                   --trafficModel=$trafficModel \
                                   --enableTraces=$enableTraces \
                                   --e2lteEnabled=$e2lteEnabled \
                                   --e2nrEnabled=$e2nrEnabled \
                                   --e2du=$e2du \
                                   --simTime=$simTime \
                                   --outageThreshold=$outageThreshold \
                                   --handoverMode=$handoverMode \
                                   --basicCellId=$basicCellId \
                                   --e2cuUp=$e2cuUp \
                                   --e2cuCp=$e2cuCp \
                                   --ues=$ues \
                                   --reducedPmValues=$reducedPmValues \
                                   --e2TermIp=$e2TermIp \
                                   --enableE2FileLogging=$EnableE2FileLogging \
                                   --minSpeed=$minSpeed \
                                   --maxSpeed=$maxSpeed" --run scenario-one 
#sleep 1;
#done