Building

Tested with the following software components:

• CCStudio 12.1.0.00007
• SimpleLink CC13xx CC26xx SDK 5.30.01.01
• SysConfig 1.10.0

Flashing

• In targetConfigs/CC1352R1F3.ccxml, replace the serial number in Debug Probe Selection. The serial number of attached XDS110 debug probes can be checked with ccs/ccs_base/common/uscif/xds110/xdsdfu -e.

Wire connections

• DIO16 (boosterpack.32): for counting inferences
• DIO11 (boosterpack.18): for measuring recharging time. Connect to VBAT_OK as 3V3 may not be low enough to be considered as GPIO 0 in a short recharging period.
• DIO19 (boosterpack.37): general indicator 0
• DIO18 (boosterpack.36): general indicator 1
• DIO21 (boosterpack.8 ): general indicator 2
• DIO3 (boosterpack.19): general indicator 3
• GND <-> GND

See pinout on CC1352R1 LaunchPad Quick Start Guide.

Note that the jumper on TDI between CC1352R1 and XDS110 (debugger) should be removed, or power will flow into MSP430/MSP432 via DIO17.