S1V3

Firmware for S1V3

What's new?

Control gimbal in the follow mode

• Gimbal allows control in follow mode by using remote control or gSDK

Control gimbal with LightBridge 2 with DJI's Remote Control.

• In Single mode
  • C1 button switch mode (LOCK -> FOLLOW -> MAPPING)
  • C2 button switch control between TILT and PAN axis.
  • C2 button press hold > 2 seconds. Turn off Gimbal.
• In Dual Mode
  • C1 button switch mode (LOCK  FOLLOW  MAPPING)
  • C2 button press hold > 2 seconds. Turn off Gimbal.
• Refer to: https://www.youtube.com/watch?v=p9fpLAZofRc&t=7s

Control gimbal with Herelink with Pixhawk Flight Controller.

Use S.Bus signal output from the Herelink for simultaneous control of Autopilot, Gimbal and camera as well.

• In Single mode
  • Scroll wheel controls the TILT or PAN axis (Channel 10)
  • Top button (Right) controls the Gimbal mode including 3 states (Toggle PAN or TILT and Reset Position) (Channel 9)
  • C button controls zoom in for camera (Channel 14)
  • D button controls zoom out for camera (Channel 14)
  • Trigger Camera (Channel 7)

Go to home position when switching the gimbal mode automatically.

Control gimbal with gSDK.

• Gremsy SDK to meet the requirements of those building solutions for various industrial applications.
• Adjust the speed, smooth and direction control of each axis.
• Adjust Data Transmission Rates of each message.

Control gimbal with Pixhawk.

• Automated aiming of the camera at a Region of Interset or manual control through MAVLink message.

Detect errors when initialization.

• Gimbal will dectect automatically when initialization and pop-up error on the new gTune with troubleshooting guide.

Start-up at random position.