Control4 WLED Preset Cycler

Control4 Driver for WLED Controller Preset Cycling and Brightness/On/Off Control

Quick Start:

WLED Controller Setup:

1. Config > WIFI Setup:
   • Set Static IP Address
2. Config > Sync Interfaces:
   • Set UDP Port (if you have multiple WLED, increment by 1 per WLED controller to not use same UDP port)
   • Tick "Send notifications on direct change"
   • Tick "Send notifications twice" (Optional, but can help incase the first UDP broadcast doesnt come through)
   • Untick Receive -> Brightness, Color, Effects and everything else in WLED Broadcast section.
3. Main Page:
   • Configure your Presets starting with ID '1' (10 is the max for now in this driver).
   • Add an additional Preset and set it as ID '99' and set it up with a default "ON" mode settings (i.e. All White)
   • NOTE: Preset '99' will be used for the C4 Lightv2 Proxy (under Lighting in UI) for On / Brightness without using the Preset Button UI.

Composer Driver Properties:

1. Enter the WLED IP address
2. Set UDP Multicast Port (if different)
3. Set the total presets you setup in WLED Controller Setup Step 3 (Maximum: 10)
4. Under Room Navigators:
   • In "Lights": You should see the WLED Driver, this is for Brightness/On/Off control.
   • In "Comfort, Listen, Security or Watch": Unhide the "WLED Presets" for the Preset Cycler UI button.
5. Refresh Navigators

Release Notes:

• Version 1: Initial Release
• Version 2: New Icons for Preset Cycling
• Version 3: Icon for Driver and LUA/XML cleanup
• Version 4: Added Custom Preset programming action for selecting WLED Presets outside of the 1-10 UI Button Cycle range.
• Version 5: Added reduced ALS support (Full ALS support may be added in the future)

Compiled Driver Available from Releases:

https://github.com/Leighm0/WLED-PresetCycler/releases