- Installed
- Planned
- PEI magnetic sheet
- 3DTouch (BLTouch)
- Raspberry Pi 4B
- 5V Power Supply
- mounted inside of the case with industrial strength Velcro (works great)
- I use a small percent of the system resources, I am rarely using over 5% of the system resources, a 2GB Pi would be more than sufficient
- Raspberry Pi camera V2
- Camera Mount
- Using a stock Ender 3 pulley cover to mount the camera on
- BLTouch needs a cover as the light is too bright for the camera
- 5V LED Lights
- 5V Power Supply
- MKS Robin Nano V3
- Raspberry Pi GPIO direct connected to board
- Move Raspberry Pi underneath if I can get the direct connect worked out
- I am concerned about how well WiFi will work underneath in an 1all metal case
- Extra USB removed so board fits the stock Nano 1.2 case w/out modifying the case
- TMC2209 stepper drivers (in UART mode)
- Raspberry Pi GPIO direct connected to board
- Klipper Firmware
- V6 Hotend
- Printable cooling system
- Titan extruder and V6 hotend
- I like this system a lot, best cooling system and hotend/extruder combo I have used
- Stock Ender 3 carriage plate
- Stock Ender 3 X axis pulley cover there are several choices if you search
- Stock Ender 3 endstop
- Chain Link going up to bed
- Before I stumbled upon this I was concerned the wires from the bed would be a wear point for failure
- This printer really needs a complete cable management system
- I have yet to find a cable management system for the Bluer that seems practical/decent
- Belt driven dual Z axis single
- This is the last big upgrade I have planned
- Fysetc S6 if/when the Nano V3 dies
- With the MKS and BTT failures I have had I do not want to run a board from either manufacture