v0.2.0

Added support for T-Display-S3
Added Brightness control (for backlight)

(also allocated the used pins, forced square pixels and did a couple of optimalizations)

Binaries for the two boards are below, install instructions in the first release.

v0.1.0

This is for experimenting only, absolute no responsibility if you brick your board.

You can try the following:

• Install wled using https://install.wled.me (0.14.3, Plain version)
• Setup WLED (Wifi and other settings)
• Upload firmware.bin using config/updates/Manual OTA update
• After board restart you should see "WLED - TTGO" on the display.
• If the display is blank, you can try to set in wleds config/led preferences/Led output/GPIO to 12 (if it is on 16)
• Also check out: https://github.com/Victoare/WLED_TTGO-TDisplay-output/tree/TTGO-TDisplay-output/usermods/usermod_v2_TTGO-TDisplay_output for further setup steps.

This build is ONLY for Lilygo/TTGO T-Display board!