A case meant to be 3d printed. This version is usable. I'll admit that certain things can be improved but personally after printing this version I am happy.
This assembly has been tested with a 2mm plate (although I guess plateless will work as well but there will be some gap between the top part of the case and the pcb.
I plan to test it with 3mm plate in the near future.
- I am using M2 3mm heat inserts for both the bottom of the case as well as for the top of the case.
- I tighten the two parts together by using a 2M screws and nuts.
- the pcb is screwed to the bottom half with flat screws
This is an improved version of the case by G-Radiation It uses M4 screws for tenting, you will need to use the corresponding nuts.
The cases hosted in this repository are based on the designs hosted in the official splitkb repository.