Skip to content

Sending interval

Jump to bottom
Pavel S edited this page May 29, 2021 · 1 revision

Sending interval is set via R9 resistor, 100K is approximately 37min, maximum interval can be set to 7200s = 2hours.

For resistor selection please consult datashet of TPL5111 section "7.5.3 Selection of the External Resistance"

During testing you might benefit from the feature to bypass the timer and send data straight away, this is where the 2P header comes handy - just short these to pins together and the board will wake up.

Creative Commons License
This documentation is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

Clone this wiki locally