Warning
i literally forgot to make the firmware lmao
Tip
If you want to make this keyboard, i would advise you to use the money you would spend on this to go to therapy.
the original idea was a QAZ with bruce-like column stagger, but due to the nature of geometry itself its hard to use both staggers at once. therefore, it has a lot of gaps. i also forgot to properly make the column stagger on both sides so the left is a bit lower than the right.
the initial reactions were unanimous: this board is hideous.
what the fuck is this
ethanbadmic
WHAT THE ACTUAL FUCK IS GOING ON HERE??
obabo
this an the sinergy board are kinda goated tbh
Anna
it looks like you spilled a tray of keycaps. i love it
calumwri
!40s
bibibuscotti
What the actual fuck is this?
Dingusaurus Derp
Why does it look like everything is tilted
Starimmezzo
mae
ban him
Joe Scotto
That's Illegal
Ruby
Why is this kind of sick tho
upset
to add to the jankiness, you can of course just mount a pcb over the other and keep it as a sandwich, or use obabo's one, which is much better but not compatible because it requires a daughter board while i use an rp2040 zero, and i swear i cannot integrate circuits so i guess obabo's case is good if you want to handwire?
this board has not been tested and i do not claim responsibility over any errors or malfunctions in the pcb, case, plate or any other component
This work falls under the Creative Commons Attribution-ShareAlike 4.0 international license. For more info, check LICENSE.md or https://creativecommons.org/licenses/by-sa/4.0/deed.en