Assembly procedure (as of the tenth of November, 2023)

The node has three main parts: The battery component, the display component, and the keypad component.

To assemble the node, one needs to find a NEW printed case (no logo, text on the side) and wash it with warm water, and carve out the 3D filler scaffolding surrounding any portholes.

Put in the display component first, and screw it in so that the large blue piece is directly flush with corner. The wires that are screwed into it should be facing the far, empty side of the case. One needs to screw it in with care. Be careful not to strip the holes by overscrewing. Use visual guidance and when the head of the screw meets the board, stop immediately.

Put in the keypad. If necessary, peel away excess printing material. Screw it down with the same procedure above. Insert washer, the nut, then knob in that order on the protruding metal piece through the exterior. This secures the case.

Next, put in the battery component, in tandem with the power button (small red plastic piece). Make sure to PEEL AWAY excess material from the button if it is still present. Orient the power button so the logo is facing the correct way outside. While holding the small red power plastic component, put in the battery component so it is flush with the red power button. Screw it in like the other parts.

Put on the back case using FLAT SCREWS (not the rounded heads). Run a test. It should be complete.