NeuroProcImager-Plus

Yun Zhao, Levin Kuhlmann (Monash University, Australia), Email: [email protected], [email protected]

NeuroProcImager-Plus is associated with the manuscript Cortical local dynamics, connectivity and stability correlates of global consciousness states.

NeuroProcImager-Plus, an extension of NeuroProcImager (Github link, Neuroimage Paper link), explores neurophysiological underpinnings of brain functions via analyzing

1. regional neurophysiological variables
2. effective connectivity between brain regions,
3. dynamic cortical stability (demo below).

Methods

Modelling the brain

The schematic of the whole-cortex model fitted to source-level MEG data is shown. The left side shows a neural mass model (NMM) and the middle shows the whole-cortex model. Each node in the whole-cortex model is a NMM. Purple lines represent connections between NMMs. The right side shows MEG sensors and reconstructed source points in the cerebral cortex. Each source time series is fitted with a NMM. In this study, MEG source time series are used whereas our framework also applies to EEG data.

Briefly, the NMM comprises three neural populations, namely excitatory (e), inhibitory (i), and pyramidal (p). The pyramidal population (in infragranular layers) driven by the external input $\mu$, excites the spiny stellate excitatory population (in granular layer IV) and inhibitory interneurons (in supragranular layers), and is excited by the spiny stellate excitatory population and inhibited by the inhibitory interneurons. Neural populations are characterized by their time varying mean (spatial, not time averaged) membrane potential, $v_n$ , which is the sum of contributing population mean post-synaptic potentials, $v_{mn}$ (pre-synaptic and post-synaptic neural populations are indexed by $m$ and $n$) and connected via synapses in which the parameter, $\alpha_{mn}$ quantifies the population averaged connection strength. $\alpha_{mn}$ is referred as the regional neurophysiological variables. In the figure above, there are four variables in a cortical region.

Coupling of two cortical regions is achieved by connecting the output of the pyramidal population in one region to the input of the pyramidal population in another region via a synapse. The synaptic connection strength from region $a$ to $b$ is referred as the inter-regional connectivity parameter $w_{ab}$. For the whole-cortex model, the input to the pyramidal population in one cortical region is formed by the combination of post-synaptic membrane potentials induced by the output of each area.

Parameter estimation

To estimate parameters of the whole-cortex model from data, we first treat each NMM in the whole-cortex model independent and apply the semi-analytical Kalman filter (AKF) that we developed in Neuroimage Paper link to estimate parameters of each NMM. The AKF is an unbiased estimator, providing the minimum mean square error estimates for model parameters, under the assumption that the underlying probability distribution of the model state is Gaussian. Briefly, the aim of the estimation is to calculate the posterior distribution of model parameters at time point $t$ given measurements up to $t$. This gives time-varying parameter estimates.

To estimate inter-regional connectition strength $w$, we use the multivariate regression model to relate the input of the pyramidal population $\mu$ in one region to the output of the pyramidal population in other regions. The multivariate regression gives an estimate for $w$ and a bias term $e$ representing the contribution from thalamus input. The estimation is done in each time window, which result in time-varying $w$ and $e$ estimates.

Dynamic cortical stability analysis

Stability analysis is performed in each time window where the averaged parameter estimates are used to define the whole-cortex model system. Equilibrium point of the system is found in each time window. To study the behaviour of the model around the equilibrium point, we linearize the model and calculate its Jacobian matrix $\mathbf{J}$ at the equilibrium point. We calculate the eigenvalues $\lambda_k$ of $\mathbf{J}$ to see if the system is stable around the equilibrium point. Precisely, we perform the eigenvalue decomposition $\mathbf{J} = U \Lambda U^\top$, where $U$ is orthonormal, $\Lambda$ is the diagonal eigenvalue matrix, and $^\top$ means the transpose conjugate. We call the real part of $\lambda_k$ the criticality index. If a criticality index is less than 0, the corresponding mode is stable. A small perturbation along the eigenvector will decay and the system can return to the equilibrium point. Conversely, if a criticality index is greater than 0, even a trivial perturbation along the eigenvector will diverge the system from the equilibrium point. When the criticality index equals 0, the system is at the neutral point along the corresponding eigenvector. In short, the system is unstable if there is at least one unstable eigenmode, and is stable when all eigenmodes are stable.

To visualize the result, we show the time course of the eigenvalue spectrum and indicate the number of unstable eigenvalues at each time point. Each unstable eigenvalue represents a distinct direction in which the system's state can diverge from the equilibrium point. The more unstable eigenvalues there are, the more directions the system has in which it can become unstable. The magnitude (specifically, the real part) of an unstable eigenvalue indicates how rapidly perturbations in that direction will grow. Systems with larger unstable eigenvalues may be more sensitive to initial conditions and external disturbances.

Demonstration

Here we provide a demonstration to show the dynamic cortical stability analysis under xenon-induced asymptotic loss of consciousness.

This showcase calculates and shows the time-evolving stability of the cerebral cortex during an xenon-induced anaesthesia experiment where a subject started with wakeful state and slowly lost responsiveness and finally recovered from unconsciousness.

To run this Case, one needs to download "regional_variable_estimates_S11.mat" from Google Drive and put it in the /Data folder. The time-evolving neurophysiological variables in each region were estimated using NeuroProcImager by fitting a neural mass model to each MEG source time series. This demonstration further estimates the inter-regional connectivity parameters, calculates the Jacobi matrices of the whole-cortex model system, and shows the time-evolving eigenvalue spectrum and the number of positive eigenvalues. This demonstration will run overnight with a standard CPU workstation. Run time highly depends on the number of the CPU cores and the size of memory. We used MEG compatible headphones to deliver a binaural auditory tone of either 1 or 3 kHz frequency of fixed stereo amplitude (approx. 76 dBA), with an inter-stimulus interval of between 2 to 4 seconds drawn from a uniform distribution.

The regional variable estimates in the file "regional_variable_estimates_S11.mat" shown below. Note that each panel in the figure shows the averaged variable estimates across 4714 cerebral cortical regions in blue line with 95% confidence interval in green band. The level of responsiveness is denoted by solid brown line and the xenon concentration level during the experiment is denoted by brown dashed line. The responsiveness level was measured by an auditory continuous performance task. Subjects were asked to respond as quickly as possible using two separate button boxes held in each hand. Use the left and right buttons on each box correspond to a low or high frequency tone, respectively, and the left and right button boxes, respectively, for the participant to indicate the absence or presence of nausea. When they were unable to answer or answered incorrectly, the responsiveness was 0%, indicating unconsciousness, and when they were able to answer correctly, the responsiveness was 100%, indicating a conscious state.

The figure below shows two snapshots of estimated connectivity between brain regions, one taken at the beginning of the experiment when the subject was conscious, and the other taken when the subject was unresponsive.

The figure below shows the dynamic cortical stability analysis under xenon-induced asymptotic loss of consciousness. The bottom panel shows the time course of the eigenvalue spectrum, where dark colors indicate high density and light colors indicate low density. The top panel shows the time course of the number of positive eigenvalues, the subject's response level, and the xenon concentration level. Throughout the experiment, the number and magnitude of positive eigenvalues ​​first decreased and then increased, corresponding to the increase and then decrease of xenon concentration. The subjects responded at the beginning of the experiment where the positive eigenvalues ​​were the largest.

Adaptation to your data

Users can prepare EEG or MEG data of the whole brain or parts of the brain in any brain state or during state transitions, and use our NeuroProcImager to estimate the regional neurophysiological variables of each brain region (that is, the region corresponding to each MEG or EEG time series). Assuming there are $N$ regions (i.e., N time series) of length $t$, and each region has $n$ neurophysiological variables, the user needs to save the estimates in a variable named "xi_hat_list" and ​​follows the structure of $n$ x $t$ x $N$ and save it into a data file (.mat). The user then replaces the value of the "file_name" variable in "run.m" by the name of the data file.

Common issues and solutions

Issue: Errors with parallel pool.

Solution: This type of errors occur when the machine runs out of the memory or loses connections to some cores. As the parallel computation heavily relies on the hardward of computers, it is suggested to reduce the number of parallel threads by defining the number of threads you want to run in parallel in line #16 in /Sources/calculate_dynamic_stability.m. By default, all cores are used in computation.