-
-
Notifications
You must be signed in to change notification settings - Fork 19
Parmmg application
lcirrott edited this page Dec 3, 2019
·
4 revisions
The ParMmg application recognize all the options accepted by mmg3d to tune the remeshing process, which are documented here.
The parallel remeshing environment is customized by a set of ParMmg-specific options, notably:
- -niter controls the number of parallel remeshing-repartitioning iterations.
- -nlayers controls by how many mesh edges a parallel interface is displaced to repartition the mesh. A value of 2 or 3 is recommended (default is 2; a too high value can worsen load balancing).
- -mesh-size controls the size (in elements) of the mesh parts to be sequentially remeshed on each process (not needed in this small example).
- -m controls the maximum amount of memory (in MB) which can be used by each process (by default, only 50% of the available memory is used).
A tutorial on the usage of the ParMmg application to adapt the mesh to an isotropic solution can be found here.