Security

Documentation of openHAB's security features

Introduction

To secure the communication with openHAB there are currently two mechanisms in place

• HTTPS
• Authentication

Authentication is implemented by SecureHttpContext which in turn implements HttpContext. This SecureHttpContext is registered with the OSGi !HttpService and provides the security hook handleSecurity. At least all authentication requests are delegated to the javax.security.auth.login.LoginContext.LoginContext which is the entry point to JAAS (http://en.wikipedia.org/wiki/Java_Authentication_and_Authorization_Service) !LoginModules.

The SecureHttpContext is currently used by the WebAppServlet and the CmdServlet which constitutes the default iPhone UI as well as the RESTApplication which provides the REST functionality.

HTTPS

openHAB supports HTTPS out of the box. Just point your browser to

https://127.0.0.1:8443/openhab.app?sitemap=demo#

and the HTTP communication will be encrypted by SSL. If one would like to add his own certificates please refer to http://wiki.eclipse.org/Jetty/Howto/Configure_SSL for more information.

Authentication

In order to activate Authentication one has to add the following parameters to the openHAB start command line

• -Djava.security.auth.login.config=./etc/login.conf - the configuration file of the JAAS !LoginModules

By default the command line references the file <openhabhome>/etc/login.conf which in turn configures a PropertyFileLoginModule that references the user configuration file login.properties. One should use all available LoginModule implementation here as well (see http://wiki.eclipse.org/Jetty/Tutorial/JAAS for further information).

The default configuration for login credentials for openHAB is the file <openhabhome>/configuration/users.cfg. In this file, you can put a simple list of "user=pwd" pairs, which will then be used for the authentication. Note that you could optionally add roles after a comma, but there is currently no support for different roles in openHAB.

Security Options

The security options can be configured through openhab.cfg. One can choose between

• ON - security is enabled generally
• OFF - security is disabled generally
• EXTERNAL - security is switched on for external requests (e.g. originating from the Internet) only

To distinguish between internal and external addresses one may configure a net mask in openhab.cfg. Every ip-address which is in range of this net mask will be treated as internal address must not be authorized though.