Assembly of the Z axis
This is the third part of the assembly process. You need to have built the X axis first.
-
Insert the bearings into the Z carriage --
-
Prepare the Z threaded rod --
-
Prepare the motor for the Z axis --
-
Insert the Z carriage screws for the spindle holder --
-
Screw the motor in place --
-
Mount the lower half of the Z carriage --
-
Mount the Z threaded rod in place --
-
Mount the top part of the Z carriage --
-
Mount the spindle tool --
-
Prepare the vacuum cleaner attachment (I) --
-
Prepare the vacuum cleaner attachment (II) --
-
Mount the vacuum cleaner attachment --
Sweet! You are almost done, the only thing remaining is to connect the electronics.
Original instructions by bq. (list of translation contributors)
License: Attribution - Share Alike - Creative Commons (http://creativecommons.org/licenses/by-sa/4.0/)
This hardware/software is provided "as is", and you use the hardware/software at your own risk. Under no circumstances shall any author be liable for direct, indirect, special, incidental, or consequential damages resulting from the use, misuse, or inability to use this hardware/software, even if the authors have been advised of the possibility of such damages.